Melitta Avanza F270-100 Operating Instructions Manual page 51

CAUTION
Contact with descaling agent may lead
to eye and skin irritation.
Observe the processing instructions on
ƒ
the packaging of the descaling agent.
CAUTION
Hot water and hot steam flowing out of
the pipe
Do not touch the steam pipe during
ƒ
and immediately after use.
Wait until the steam pipe has cooled
ƒ
down.
ATTENTION
Use of unsuitable descaling agents and
failure to observe the processing instruc-
tions may damage the appliance.
Only use Melitta® ANTI CALC liquid des-
ƒ
caling agent for fully automatic coffee
machines.
Observe the processing instructions on
ƒ
the packaging of the descaling agent.
ATTENTION
A water filter may be damaged if it is
screwed in during the descaling pro-
gramme.
Remove the water filter (see Fig. 19 on
ƒ
page 53).
Place the water filter into a vessel filled
ƒ
with tap water during the descaling
programme.
The water filter can be reinserted and
ƒ
reused when the descaling programme
is complete.
The descaling program lasts approx.
25 minutes and should not be interrupted.
The descaling programme runs in several
stages. Progress is indicated by the num-
ber of coffee beans displayed.
The appliance performs several rinsing
operations during the descaling pro-
gramme. The drip tray is also rinsed.
Care and maintenance
Requirement: The appliance is ready for
operation.
Press the "Service" button for
1.
more than 2 seconds to call up Service
mode 1.
Press the "Service"
2.
button repeatedly unit the display for
the descaling programme appears.
Press the "Service" button for
3.
more than 2 seconds to start the
descaling programme.
» The Descaling display
flashes until the descaling pro-
gramme is finished.
The first stage of the descaling
programme starts. One coffee bean lights
up.
The Drip tray display lights
»
up and requests you to empty the
drip tray and the coffee grounds
container.
4. Empty the drip tray and the coffee
grounds container.
5. Insert the drip tray without the coffee
grounds container.
6. Place the coffee grounds container
beneath the Cappuccinatore.
The Water display lights up and
»
requests you to fill the water tank
with descaling fluid.
7. Remove the water tank.
8. Fill 0.5 litres of descaling fluid into the
water tank. Observe the corresponding
instructions for use of the fully auto-
matic coffee maker descaling agent.
9. Insert the water tank again.
The second stage of the descaling
programme starts. Two coffee beans light
up.
The descaler needs approx. 20 minutes to
take effect, Several rinsing operations are
carried out during this time.
» The Steam display then lights
up and requests you to open the
"valve".
51