First Steps; Unpacking The Appliance; Checking The Delivery Contents; Installing The Appliance - Melitta Avanza F270-100 Operating Instructions Manual

3

First steps

This chapter describes how to prepare
your appliance for use.

3.1 Unpacking the appliance

Unpack the appliance. Remove the
ƒ
packaging material, the adhesive
strips and the protective films from the
appliance.
Keep the packaging material for trans-
ƒ
port and any return shipments.
Information
The appliance may contain traces of coffee
and water. The appliance has been tested
in the factory to ensure that it functions
perfectly.
3.2 Checking the delivery
contents
Check the completeness of delivery using
the following list. If parts are missing,
contact your retailer.
ū Cappuccinatore
ū Milk hose
ū Screw-in aid for the water filter
ū Test strip for determining the water
hardness.

3.3 Installing the appliance

Observe the following instructions:
ū Do not install the appliance in damp
rooms.
ū Install the appliance on a stable, flat
and dry surface.
ū Do not install the appliance in the vicin-
ity of sinks or the like.
ū Do not install the appliance on hot
surfaces.
ū Install the appliance at a sufficient
distance (approx. 10 cm) from the wall
and other objects. The space above the
appliance should be at least 20 cm.
ū Route the power cable so it cannot be
damaged by edges or hot surfaces.

3.4 Connecting the appliance

Observe the following instructions:
ū Check that the supply voltage matches
the operating voltage specified in the
technical data (see table Technical data
on page 55).
ū Only connect the appliance to a prop-
erly installed earthing contact socket. If
in doubt, consult a specialist electrician.
ū The earthing contact socket must have
a fuse of at least 10 A.
3.5 Connecting the
Cappuccinatore
You can prepare hot water and milk foam
with the Cappuccinatore.
21
Fig. 5:

Connecting the Cappuccinatore

1. Connect the Cappuccinatore to the
steam pipe (21). Slide the connection
of the Cappuccinatore to the stop of
the steam pipe.
2. Connect the milk hose (25) to the Cap-
puccinatore.
3. If you do not want to use milk, clamp
the milk hose in the holder (23).
3.6 Switching on the appli-
ance for the first time
Once you switch on the appliance for the
first time, the appliance performs auto-
matic rinsing. Hot water first flows out of
the Cappuccinatore, then out of the outlet.
The appliance is vented.
First steps
23
25
37