Storage - Gravely Pro-Ride 260 Owner's/Operator's Manual

Belt Routing – Pumps
Pump
Figure 33
9. Reinstall the deck belt drive on the
clutch and make sure it is routed
properly on all pulleys.
WARNING: AVOID INJURY.
Read and understand entire
Safety section before proceeding.
SHORT TERM
NEVER spray unit with high-pressure water
or store unit outdoors.
Inspect unit for visible signs of wear,
breakage or damage.
Keep all nuts, bolts and screws properly
tightened and know unit is in safe working
condition.
Store unit in a cool, dry protected area.
LONG TERM
Clean unit thoroughly with mild soap and low-
pressure water and lubricate. (See
Maintenance Schedule on page 24.) Touch
up all scratched painted surfaces.
Remove weight from wheels by putting
blocks under frame or axle.
Clean and charge the battery. Charge battery
every three to four weeks when storing unit.
Fuel System
Gasoline left in the fuel system for extended
periods without a stabilizer will deteriorate,
resulting in gum deposits in the system.
These deposits can damage the carburetor
and the fuel hoses, filter and tank. Prevent
deposits from forming in the fuel system
during storage by adding a quality fuel
stabilizer to the fuel. Follow the
recommended mix ratio found on the fuel
stabilizer container.
To treat the fuel system for storage:
Pump
Idler
Engine
10. Engage the deck tension by returning
the deck tension arm back to the slot.
(See Deck Belt Removal and Installation
on page 39.)
11. Reattach the negative battery cable.

STORAGE

1. Add fuel stabilizer according to
manufacturers's instructions.
2. Run engine for at least 10 minutes after
adding stabilizer to allow it to reach the
carburetor.
NEVER store the engine with fuel in the fuel
tank inside of a building with potential
sources of ignition.
TO TAKE THE UNIT OUT OF
STORAGE
1. Refer to the engine service manual to
prepare the engine for service.
2. Put fresh, clean fuel in the fuel tank.
3. Begin the maintenance schedule.
4. Charge the battery.
GB - 40