Motion Detection - D-Link DCS-2670L User Manual

Section 3: Configuration
Motion detection enables the camera to monitor the video feed for movement. You can specify what part of the image to monitor for motion and
adjust the sensitivity settings. For more details, refer to Event Setup on page 37. After making your changes, click the Save Settings button for
them to take effect.
Enable Video
Select this box to enable the motion detection feature of your camera.
Motion:
Note: If you do not draw an area to monitor for motion, motion will not
be detected by the camera.
Sensitivity:
Specifies how sensitive motion detection will be from 0% to 100%. A
low sensitivity setting means that there must be large changes between
two images in order to detect motion, and a high sensitivity setting
means that even small changes will cause motion to be detected.
Draw Motion Area:
Use your mouse to click and drag on the areas that you would like to
monitor for motion.
Erase Motion Area: To erase a motion detection area, simply click on the red square that you
wish to remove.
Right click on the camera image to bring up the following menu
options:
Select All: Draws a motion detection area over the entire screen.
Clear All: Clears any motion detection areas that have been drawn.
Restore: Restores the previously specified motion detection areas.
D-Link DCS-2670L User Manual

Motion Detection

34