Removing The Dual Thermal Valve (Main Oven) - Fisher & Paykel DCS RGS Series Service Manual

REMOVING THE DUAL THERMAL VALVE (MAIN OVEN)

WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before operating.
Failure to do so can result in death or electrical
shock.
1. Turn off the gas and disconnect power to the range.
2. Pull the range away from the wall so you can access the
rear panel and gas line to the range.
3. Remove the three screws from the island trim.
3 Island Trim Screws
NOTE: The screw numbers may vary.
4. Remove the six screws from the island back trim, and
lift the island back trim and the island trim up and off
the range.
6 Island Back Trim Screws
SERVICING THE COMPONENTS
5. Remove the inlet and two outlet gas lines from the dual
thermal valve.
6. Disconnect the four wire connectors from the dual
thermal valve terminals.
Dual Thermal Valve Gas Inlet Line
Blk Red
IR Gas Line
42
Blk Brn
Main Bake Gas Line