Toshiba RAS-18S3KV-E Service Manual page 90

No. Part name
ƒ Horizontal louver
„
Evaporator
(Heat exchanger)
Procedures
1) Remove shaft of the horizontal
louver from the back body.
(First remove the left shaft, and
then remove other shafts while
sliding the horizontal louver
leftward.)
1) Follow to the procedure in the item
2) Remove the pipe holder from the rear side of the main unit.
3) Remove two fixing screws at the left side of the end plate of the heat exchanger.
2 Screws
4) Remove two fixing screw on the
heat exchage fixing holder to separate the
heat exchage from the back body.
.
‚
– –
89
FILE NO. SVM-15009
Remarks
Screw
Screw