Scart Connector Wiring (Ext1, Ext2 Or Ext3); Wiring The Mains Power Supply Plug (Uk Only) - Samsung CS34A10 Owner's Instructions Manual

S58A_UK(02796A-01) 10/30/03

SCART Connector Wiring (EXT1, EXT2 or EXT3)

If you wish to connect other equipment via the SCART connectors on your television, contact your
dealer or a qualified technician to wire the A/V cable as illustrated below.
Pin
1 Audio output R
2 Audio input R
3 Audio output L
4 Audio chassis return
5 Video chassis return (RGB blue)
6 Audio input L
7 RGB blue input
8 Switching voltage
9 Video chassis return (RGB green)
10 AV-Link (Ext 1)
11 RGB green input
➢
Pins 5, 7, 9, 11, 13, 15 and 16 are used for RGB processing and are only wired on
the EXT1 or EXT3 connector.

Wiring the Mains Power Supply Plug (UK Only)

IMPORTANT NOTICE
The mains lead on this equipment is supplied with a moulded plug incorporating a fuse. The value of the fuse is
indicated on the pin face of the plug and, if it requires replacing, a fuse approved to BSI1362 of the same rating
must be used.
Never use the plug with the fuse cover omitted if the cover is detachable. If a replacement fuse cover is required,
it must be of the same colour as the pin face of the plug. Replacement covers are available from your dealer.
If the fitted plug is not suitable for the power points in your house or the cable is not long enough to reach a power
point, you should obtain a suitable safety approved extension lead or consult your dealer for assistance.
However, if there is no alternative to cut off the plug, remove the fuse and then safely dispose of the plug.
Do NOT connect the plug to a mains socket as there is a risk of shock hazard from the bared flexible cord.
IMPORTANT
The wires in the mains lead are coloured in accordance with the following code:
BLUE - NEUTRAL
As these colours may not correspond to the coloured markings identifying the terminals in your plug, proceed as
follows:
The wire coloured BLUE must be connected to the terminal marked with the letter N or coloured BLUE or BLACK.
The wire coloured BROWN must be connected to the terminal marked with the letter L or coloured BROWN or RED.
WARNING: DO NOT CONNECT EITHER WIRE TO THE EARTH TERMINAL, WHICH IS MARKED WITH THE
LETTER E OR BY THE EARTH SYMBOL , OR COLOURED GREEN OR GREEN AND YELLOW.
10:16 PM Page 63
Signal
BROWN - LIVE
Pin Signal
12 -
13 Video chassis return (RGB red)
14 -
15 RGB red input
16 Blanking signal (RGB switching)
17 Video chassis return
18 Blanking signal ground
19 Video output
20 Video input
21 Screening/chassis return
ENG
63