Start-Up / Operation; Operation; Stopping; Cleaning - Stiga V 302 S Operator's Manual

EN
Driver seated.
Parking brake
engaged.
The PTO is
activated.
Driver seated.
Parking brake
engaged.
The PTO is
deactivated.
Engine running.
Engine running.
Cutting-means
engaged
Set the cutting-
means assembly
to the maintenan-
ce position.
7.6

START-UP / OPERATION

When using the machine, the bonnet
must be closed and fastened shut.
Always use full throttle when using the
machine.
When starting the machine, wait for
2 seconds in starting position before
starting the engine.
1. Check the PTO is disengaged (9:D).
2. Do not keep your foot on the service/drive
brake (8:G)
Cold start.
1. Engage the transmission; push the lever in
(10:A).
2. Activate the parking brake (8:D)
3. Put the choke on (where applicable) (8:I).
4. Turn the key in the ignition (8:L) and start the
engine.
5. When the engine is running, gradually acce-
lerate (8:I) to maximum operating speed.
Before starting work with the machine,
wait a few minutes for the oil to warm up.
16
Try to start The motor
the engine. does not
start.
Try to start The engine
the engine. turns on
The driver The engine
gets up from is switched
the seat. off.
The me- Cutting-
chanical means assy
accessory stop.
lift pedal is
taken to the
transport
position.
Try to engage Cutting-me-
the cutting ans assy do
means not engage.
assembly.
ENGLISH
Warm start.
1. Engage the transmission; push the lever in
(10:A).
2. Activate the parking brake (where applicable)
(8:D)
3. Turn the control to full throttle (8:I)
4. Turn the key in the ignition (8:L) and start the
engine.
To proceed see the instructions provi-
ded in heading 7.6.1.

7.6.1 Operation

• Press the pedal (8:D) right down then release it.
• Activate the pedal (8:G) to move the machine.
• Go to the work area.
• If front accessories have been installed, acti-
vate the PTO (9:D)
• Commence work.
7.7

STOPPING

To stop the machine, proceed as follows:
• Disengage the PTO (9:D).
• Engage the parking brake (8:D).
• Turn off the engine by turning the ignition key.
If you have to leave the machine unat-
tended and remove the key from the
ignition.
The engine may be very hot just after it
has been switched off. Do not touch the
silencer.Burns hazard.
7.8

CLEANING

To reduce the risk of fire, keep the engi-
ne, silencer, battery and fuel tank free
from grass, leaves and oil.
To reduce the risk of fire, regularly
check the machine for oil and/or fuel
leaks.
Never use high-pressure water jets.
This can damage axle seals, electrical
components, the hydraulic valves
Always clean the machine after use. To cle-
an the machine adhere to the instructions
provided below:
• Clean the motor (14:A) cooling air intake.
• After cleaning using water, start the machine
and any cutting device assy to remove any wa-
ter which may otherwise end up in the bearings
and cause damage..
(Translation of the Original Instructions)