Advertisement
Operating instructions
read the entire iMpOrtant SaFety inFOrMatiOn section at the beginning of this
manual including all text under subheadings therein before set up or use of this product.
tO preVent SeriOuS inJury FrOM acciDentaL OperatiOn:
Make sure that the power Switch is in the off-position and unplug the tool from
its electrical outlet before performing any procedure in this section.
tool changing
Bit installation
WarninG! tO preVent SeriOuS inJury:
Use only rotary cutting bits of the correct shank
diameter for the collet mounted. Use only rotary
cutting bits suitable for the speed of the tool.
WarninG! tO preVent SeriOuS inJury:
Carefully inspect router bits for cracks, chips, or
other damage before installing. Do not use bits
that have been dropped, cracked, or damaged.
The bit may shatter causing serious injury.
1. Use only bits (sold separately) with 1/4" shank size,
that are marked as suitable for the type of material
being cut, and are marked with a speed equal or
higher than the maximum speed marked on the tool.
Do not use a bit with a cutting diameter
larger than the opening in the base.
edge Guide installation
Use the Edge Guide to make cuts parallel
to the edge of a workpiece, or following a
guide clamped onto the workpiece.
1. Loosen Edge Guide Knob, then install Edge
Guide with Fence facing inward and down.
2. Tighten Edge Guide Knob securely.
3. Loosen Fence Knob, adjust
Fence, then tighten Knob.
Item 62659
For technical questions, please call 1-888-866-5797.
2. Turn Router upside down, loosen
Base Knob and remove Base.
3. Place Small Wrench over Spindle
to keep it from turning.
4. Using Large Wrench, turn Collet counterclockwise
to loosen, but do not remove.
5. Insert bit shank end into Collet as far as it
will go, then pull up slightly so there is a
minimum 1/16" gap at bottom of bit.
6. Place Small Wrench on Spindle and Large
Wrench on Collet Nut, then tighten Collet Nut.
7. Replace Base on Motor and tighten Base Knob.
Fence
Knob
edge Guide
Knob
Fence
Page 9
Advertisement
