Advertisement
General instructions For use
1. Mark cut line on workpiece.
2. Turn Power Switch off, then plug Power Cord into
the nearest 120VAC, grounded electrical outlet.
WarninG! tO preVent SeriOuS inJury: Verify
that workpiece has no hidden utility lines before cutting.
3. Turn Power Switch on.
4. Run the tool for about 10 seconds before
routing to ensure all moving parts are running
smoothly, and there are no loose parts, rattles,
or sparking that would indicate damage.
note: Determine optimum speed by testing on scrap
material until you are able to produce a smooth cut with
no burnishing or burn marks. Burn marks are caused by
moving too slowly through wood. Feeding Router too
quickly, or trying to remove too much material in a single
pass creates a rough cut and can overload the motor.
5. Allow bit to reach full speed before
contacting workpiece.
6. Slowly engage workpiece, do not force
Router down into workpiece.
7. The bit rotates clockwise. Adjust
for this while cutting:
a. For most materials it is best to move the Router
from left to right as facing the workpiece.
b. When cutting outside edges, move the
Router counterclockwise. When cutting
inside edges, move the Router clockwise.
c. On vertical surfaces, start and end cut
at the top to prevent waste material
from falling onto the rotating bit.
Page 12
For technical questions, please call 1-888-866-5797.
8. When using the Fence: Cut parallel to edge
of workpiece with Fence following edge.
9. When using a temporary Guide: Cut with
Fence following edge of temporary guide.
10. When making a circle cut: With nail
in place through center hole of Fence ,
plunge the bit into workpiece and rotate
Router in a circle around the nail.
11. When using the roller Guide: Cut the
edge of the workpiece with the Roller Guide
following the edge of the workpiece.
note: Use two or more passes for deep cuts, especially
in the case of hardwood. When cutting grooves
depth of cut should be limited to 1/8" per pass.
WarninG! tO preVent SeriOuS inJury:
The tool will restart automatically if stalled.
12. After completing cut, raise Router so bit is clear of
workpiece, and turn Power Switch off. Do not set
Router down until bit has come to a complete stop.
13. To prevent accidents, turn off the tool and
unplug it after use. Clean, then store the
tool indoors out of children's reach
Item 62659
Advertisement
