Advertisement
Setting up a temporary Guide
Clamp a temporary guide to the workpiece to make a
straight cut which is not parallel to edge of workpiece.
1. Clamp a suitable straight board across
workpiece parallel to desired location of cut.
2. Loosen Edge Guide Knob, then install Edge
Guide with Fence facing outward and up.
3. Tighten Edge Guide Knob securely.
4. Measure proper distance from bit to Fence.
5. Loosen Fence Knob, adjust
Fence, then tighten Knob.
circle cutting
Use the center hole in the Fence as a
pivot point when cutting circles.
1. Install Fence according to Setting up a
Temporary Guide on page 10.
2. Loosen Fence Knob, set distance from center hole
in Fence to far edge of bit, equal to radius of circle.
3. Tighten Fence Knob.
4. Align center hole in Fence with center point of circle.
5. Drive a nail through center hole
to secure Fence in place.
Page 10
For technical questions, please call 1-888-866-5797.
edge Guide
Knob
Hole
(for circle
cuts)
Fence
edge Guide
Knob
center
Hole
Fence
Knob
Fence
edge
Guide
Fence
Knob
edge
Guide
Item 62659
Advertisement
