Advertisement
roller Guide installation
The Roller Guide trims in relation to both the workpiece's
top surface and its edge surface. The Router must
be adjusted to cut accurately in two dimensions.
1. Assemble the Roller Guide as shown.
Attach to the Router Base.
2. Adjust the router Base so the cutting
depth will be flush with the surface that
you will be trimming to match.
3. Loosen the Edge Guide Knob and adjust
the Roller Guide so that its Roller Wheel is
below the bit by approximately 3/4" to 1". Tighten
it in position using the Edge Guide Knob.
4. Center the cutting bit over the edge to be
trimmed by loosening the Roller Guide Locking
Knob and sliding the Roller Wheel into position.
Tighten the Roller Guide Locking Knob.
note: To make fine adjustments, partially loosen
Roller Guide Locking Knob and use the Roller
Guide Fine Adjustment. When the adjustments are
finalized, tighten the Roller Guide Locking Knob.
5. Make a test cut on a piece of scrap material
to ensure that the adjustment is correct.
adjusting cutting Depth
Set the depth of cut using the scale
marked on the side of the Router.
1. Loosen Base Knob. Slide Base downward so
the router bit is retracted within the Base.
2. Place Base on a flat surface, and slide the Motor
down in the Base until the tip of bit contacts
the work surface. Tighten Base Knob.
3. Motor housing depth scale indicates
starting position. Starting position will
vary depending on bit used.
Workpiece and Work area Set up
1. Designate a work area that is clean and well lit.
The work area must not allow access by children
or pets to prevent distraction and injury.
2. There must not be objects, such as utility lines,
nearby that will present a hazard while working.
3. Route the power cord along a safe route to reach
the work area without creating a tripping hazard or
exposing the power cord to possible damage. The
power cord must reach the work area with enough
extra length to allow free movement while working.
Item 62659
For technical questions, please call 1-888-866-5797.
edge Guide
Knob
roller Guide
Fine
adjustment
roller Guide
Lock Knob
4. Add desired depth of cut to starting
position. Example: If starting position
is 1/2" and desired depth of cut is 1/4",
correct adjustment on the scale is 3/4".
5. Loosen Base Knob, and raise Motor until
the scale shows the correct reading;
in this example 1‑1/2". Tighten Base Knob.
6. Make a test cut on a piece of scrap material
to ensure that the adjustment is correct.
4. Secure loose workpieces using a vise or clamps
(not included) to prevent movement while working.
5. There must not be objects, such as utility lines,
nearby that will present a hazard while working.
6. Refer to maximum cutting depth in
Specifications on page 8.
roller
Wheel
Page 11
Advertisement
