Table of Contents
Advertisement
7. Help
The power / linking LED Indicator on the parent unit does not turn on.
•
Check whether the parent unit is powered on.
•
Check whether the batteries are correctly installed and not drained.
•
Connect the parent unit to the power supply to recharge it.
The power / linking LED indicator on the parent unit flashes.
•
The parent unit and the baby unit may be out of range with each other.
Reduce the distance between the units. Make sure the distance between
the parent unit and baby unit is within the operating range.
•
The baby unit may be powered off. Press and hold
power it on.
Unable to hear the sound or baby cry from the parent unit.
•
The volume level in the parent unit may be set too low. Increase the volume
level of the parent unit. Refer to section 6.3 for volume level settings.
•
The parent unit and the baby unit may be out of range with each other.
Make sure the distance between the parent unit and baby unit is within the
operating range.
The Digital Audio Baby Monitor system produces a high-pitched noise.
•
The parent unit and the baby unit are too close with each other. Move the
baby and parent units further apart. Make sure the distance between the
parent unit and baby unit is within the operating range.
•
The speaker volume of the parent unit may be set too high. Decrease the
volume of the parent unit. Refer to section 6.3 for volume level settings.
Powered by non-rechargeable batteries.
If for any reason the Ni-MH batteries are lost and you would like to use the
baby monitor, you can install AAA size non-rechargeable batteries, such as
alkaline batteries, to power your baby monitor. In this case, make sure the AC
power adapters are not connected to the units for charging.
For more support, you can reach us at: motorolanursery.com/support or
+1-800-763-2207 (United States and Canada).
on the baby unit to
9
Advertisement
Table of Contents
