Protecting A Recorded Cassette; Recording A Programme Immediately - Samsung CHT-500 Instruction Manual

Protecting a Recorded Cassette

Video cassettes have a safety tab to prevent accidental erasure.
When this tab has been removed, you cannot record on the tape.
1
If you wish to protect a cassette, break off the tab using a small
screwdriver.
2
To re-record over a protected cassette (safety tab broken),
cover the hole with adhesive tape.

Recording a Programme Immediately

Before recording a programme, you must have preset the corres-
ponding station (unless you are recording via an external video
source). If you have not done so, refer to pages 19 and 20.
1
Switch on the television.
2
To monitor the programme being recorded, select the television
channel reserved for use with your DVD-VCR (or the AV input if
used).
3
Insert the cassette on which the programme is to be recorded,
with the window visible and the safety tab intact or the opening
covered with adhesive tape.
Result: The DVD-VCR is switched on automatically.
4
Select:
The station to be recorded using the PROG ( or ) buttons
or
The LINE source using the INPUT SEL. button for asatellite
tuner or external video source
Result: The station number is displayed and the programme
can be seen on the television.
5
Select the recording speed by pressing the SPEED button as
many times as required (see page 30).
6
Hold REC ( ) down for a while to start recording.
Result: The record indicator appears on the television and
DVD-VCR display. An index is recorded on the tape
(see page 38).
7
To stop recording, press
If your DVD-VCR ejects the cassette when you start
recording, check to make sure that the cassette's
safety tab is intact or that the opening (created by a
broken safety tab) is covered with adhesive tape.
If you reach the end of the tape while recording, the
cassette rewinds automatically.
once.
VCR
1
VCR
4
4
6
5
7
GB
31