Info Menu; Start Up - Cadel SWEET3 7 User Manual

• Press "menu" to confirm.
• Select the test to be performed with the + - keys
• Press "menu" to confirm and "esc" to exit
k - "Chimney Sweep Function"
To activate the "Chimney Sweep Function" function act as follows:
• Press the "menu" button.
• Scroll to "Settings" using the arrows
• Press "menu" to confirm.
• Scroll to the "Chimney Sweep Function" function using the arrows.
• Press "menu" to confirm.
• Select "On" with the + - keys (Off by default)
• Press "menu" to confirm and "esc" to exit
l - Technical Menu
To access the technical menu one must contact an assistance centre as one needs a password to enter.
To intervene on the "Technical Menu" act as follows:
• Press the "menu" button.
• Scroll to "Settings" using the arrows
• Press "menu" to confirm.
• Scroll to "Technical Menu" using the arrows.
• Press "menu" to confirm.
• Select "Product Type", "Service", "Status Memory", "Parameters" with the + - keys.
• Press "menu" to confirm and "esc" to exit
9.5

INFO MENU

• Product Type
• Firmware Version
• Software info
• Total hrs.
• Ignition N.
• Rpm Smoke Fan
• Smoke Temp.
• Air Fan Voltage
• Screw Loading
• Fire
9.6

START UP

We remind you that the first ignition must be carried out by a specialized and authorixed technician who will check that all is
installed in compliance with current regulations and checks the efficiency.
• If inside the combustion chamber there are booklets, manuals, etc..., remove them.
• Check if the door is correctly closed.
• Check if the stove is correctly inserted in the electric socket.
• Before switching the stove on, assure you the burning pot is clean.
• To start the stove, keep the P1 button pressed until the ON sign and a flashing flame to its side appear. The ignition resistance
pre-heating starts. After some seconds the feed screw loads pellets and the resistance pre-heating continues. When the tem-
perature is high enough (after about 5-8 minutes), ignition is considered to be completed.
• Once the ignition step is complete, the stove moves into operating mode and shows the selected heat output, the ambient
temperature and the big flame (see Fig. 9).
• If the ambient temperature value exceeds the limit set on the button panel in the temperature set, the heat output is brought
to its lowest value and the small flame is shown (see Fig. 10). When the ambient temperature decreases below the set tem-
perature, the stove goes back to the set output.
12
Stufe a pellet