www.ti.com
3.4 Launching the OPT300x/4xxxEVM Software
With the OPTEVM properly connected, launch the Latte OPTEVM GUI software from the Windows Start menu.
The software launches with a screen similar to that shown in
the EVM variant. This section describes the following devices.
OPT4001EVM
OPT4001DTSEVM
OPT3005DTSEVM
OPT4048DTSEVM
OPT4001DNPQ1EVM
Details on additional variants are covered in the following section though the software operation is the same for
each variant.
If the message shown in
Figure 3-12
that the OPTMB EVM board was not detected. The device name varies according to the OPTEVM selected.
Check the USB connection and that the OPTMB EVM board appears in the device manager as shown. A green
SBOU293B – NOVEMBER 2022 – REVISED JULY 2023
Submit Document Feedback
Table 3-1. Section Supported Devices
Figure 3-11. OPTEVM Main Operation Screen
appears when the OPTEVM GUI software is launched, then this means
Copyright © 2023 Texas Instruments Incorporated
Figure
3-11. The exact GUI screen varies based on
Light Sensor Evaluation Modules
OPTEVM Software
11