Table of Contents
Advertisement
OPTEVM Software
3.3 Typical OPTEVM Hardware Setup
Plug the male USB-C cable to the OPTMB EVM board and then plug the male USB-A cable into the computer.
The green light lights up on the EVM as shown in the figure below.
The figure below shows the typical response when the OPTEVM is plugged into the USB port of the computer
for the first time. Typically, the computer responds with a Found New Hardware, USB Device pop-up dialog
window. The pop-up window then typically changes to Found New Hardware, USB Human Interface Device. This
pop-up indicates that the device is ready to be used.
Figure 3-10. Typical Response After Connecting OPTEVM to the Computer
Connect the EVM via USB to the PC. If Windows shows a notification that a driver is not found for the device
connected, then see the instructions to manually install drivers in
10
Light Sensor Evaluation Modules
Figure 3-9. Typical Hardware Connection
Copyright © 2023 Texas Instruments Incorporated
Section 5.1
before proceeding.
SBOU293B – NOVEMBER 2022 – REVISED JULY 2023
www.ti.com
Submit Document Feedback
Advertisement
Table of Contents
