Table of Contents
Advertisement
Finalizing the Installation
Remove the manifold covers.
NOTE: Discard the orifice gaskets and the rear manifold cover. Reinstall the front manifold cover after
changing the orifices.
3. Follow the directions below to replace the orifice.
a
Slide the air shutters to provide access to the orifices.
b
Remove and discard the two gaskets on the front burner orifice.
Adjustable Wrench
Orifice
e
Screw each LP orifice until orifice
protrudes 15/16" (23.8mm)
indicating full insertion (use
wrench to support manifold when
re-attaching orifice).
NOTE:
The "#C55" orifice
has a hole here.
© Travis Industries
Use a adjustable wrench to support the
c
manifold while removing each
orifice with a 1/2" wrench.
1/2" Open End Wrench
Manifold
5/3/2021 - 1554
(for qualified installers only)
Apply thread sealant to the LP orifices
prior to installation. Use the chart below to
identify the correct orifices.
15/16"
Look here for the orifice identification
23.8mm
564 35k Orifice Numbers
Front
Rear
When installed, the hole
must be horizontal.
d
NG
LP
#46
#58
#47
#C55
564 GSR2 35K CF (AUST)
49
Advertisement
Table of Contents
