Ac Smart / Acp Controller Setup - LG ARND DCR4 Series Installation Manual

1. Under the AC Smart / ACP "Settings" tab, find and click on "Installing".
2. AC Smart: Press on the "AC Smart [00]" tab, go to "Registration Status", and change
the CH1 setting to "MODBUS_9600".
ACP: Press on the "ACP [00]" tab and change the CH6 setting to "MODBUS_9600".
3. Click "Auto Search" to find the devices connected to the controller.
4. After the search is complete, click "Send All".
Units can be added by clicking "Add Unit", and then clicking on the buttons next to the
name(s) of the applicable devices. After all necessary units are selected, click "Apply".
5. Click "Send All" to finish adding the device(s).
Figure 66: Clicking "Auto Search" (Step 3).
Figure 68: Adding Units (Step 4).
Due to our policy of continuous product innovation, some specifications may change without notification.
©LG Electronics U.S.A., Inc., Englewood Cliffs, NJ. All rights reserved. "LG" is a registered trademark of LG Corp.

AC Smart / ACP Controller Setup

Figure 64: Clicking "Installing" Under the AC
Smart / ACP "Settings" Tab (Step 1).
Figure 65: Changing CH1 Setting to "MOD-
BUS_9600" (Step 2).
Figure 67: Clicking "Send All" (Step 4).
Figure 69: Clicking "Send All" to Finish Adding Devices (Step 5).
CONTROLLER
67