Potterton SIRIUS THREE FS 70 Installation Manual page 78

10 Settings
Parameter number
Heating Heating Heating
circuit 1 circuit 2 circuit 3
750 1050 1350
760 1060 1360
809 1109 1409
834 1134 1434
850 1150 1450
851 1151 1451
855 1155 1455
856 1156 1456
Tab.60 Temps / mode hot water menu
Parameter Parameter
number
1600 Operating mode
1610 Hot water temp
setpoint
1612 Reduced temp
setpoint
78
Parameter Description
Room influence Influence of the room temperature and the
outside temperature on calculating the flow
temperature: ---%: Simple regulation in ac­
cordance with outside weather conditions:
1...99%: Regulation in accordance with out­
side weather conditions with room tempera­
ture influence.
100%: Regulation in accordance with the
room temperature only.
Room temp Cuts the circulating pump if the room tempera­
limitation ture exceeds the current set point + parameter
760, 1060, 1360.
Continuous pump No : The heating circuit / boiler pump may be
operation shut down during an accelerated decline in
temperature or when the room temperature
set point is reached.
Yes : The heating circuit / boiler pump also
continues to run during the accelerated de­
cline in temperature and when the room tem­
perature set point is reached.
Actuator running Setting the stroke of the servomotor on the
time mixing valve used
Floor curing Controlled screed-drying function:
function
Off : The function is inoperative.
Curing/functional heating : Active for 7 days,
3 days at 25 °C and 4 days at 55 °C.
Curing heating : Active for 18 days, 6 days
from 25 °C to 55 °C increasing by 5 °C a
day, 6 days at 55 °C, 6 days from 55 °C to
25 °C diminishing by 5 °C a day.
Functional/curing heating : "Functional Heat­
ing" cycle first, and then "Ready for Occupa­
tion".
Manually : Regulation is based on the "Man­
ual Control Drying" set point.
Floor curing setp The flow temperature set point of the "Manual"
manually controlled drying function can be set separately
for each heating circuit.
Floor curing setp Displays the current day of the controlled
current screed-drying function. With '---' the function is
deactivated.
Days Displays the current flow temperature set point
complete.current of the controlled screed-drying function. With
'---' the function is deactivated.
Description
Off: Permanent running at the frost protection set point.
On : Domestic hot water loading is done automatically at the
comfort set point.
Eco : The temperature maintenance function is deactivated.
DHW set point during release times
Reduced temperature set point outside release times
Unit Factory set­
ting
% 50
°C 0.5
– No
seconds 30
S Off
°C 25
- '---'
- '---'
Factory setting
On
60°C
35°C
7609493 - v11 - 18052020