Puréeing
WARNING! RISK OF INJURY!
►
Never use containers made from glass or
other easily breakable materials . These con-
tainers may be damaged and cause injuries .
ATTENTION! PROPERTY DAMAGE!
►
Never use the blender e for hard foodstuffs
such as: coffee beans, ice cubes, sugar, cereals,
chocolate, raw/hard vegetables etc . This could
result in serious damage to the appliance .
►
Do not use the blender e to purée boiling
food (e .g . soups) . Remove the pot from the
hotplate before puréeing .
1) Use the blender e to purée foods .
Kneading
Whisks r
hooks t for
for stirring
kneading
batter or cake
heavy doughs,
mixture or
e .g . yeast
for whipping
dough .
cream .
2) Open the safety catch of the blender socket 4
by pushing it to the side and holding it firmly .
NOTE
►
The blender e can only be used if the whisks r
or the kneading hooks t are not installed .
3) Push the blender e into the blender socket 4
and push it down firmly . The blender e must
audibly click into place .
4) To avoid overflowing, the container used for
blending should only be filled to about 2/3 of
its capacity . Select a suitably large container .
■
8
│ GB │ IE │ NI │ CY
NOTE
►
►
5) Press the Turbo button / 2 . Keep the Turbo
ATTENTION! PROPERTY DAMAGE!
►
6) When you have finished working with the
ATTENTION! PROPERTY DAMAGE!
►
Blender e
for puréeing
fruits/
7) To remove the blender e from the blender
vegetables,
e .g . apples .
8) Remove the blender e with a snapping motion
NOTE
►
Ensure that there is a sufficient amount of
liquid/purée in the purée container .
To ensure effective mixing of the ingredients,
the food should cover at least the lower section
of the blender e .
Do not switch the hand mixer on until the
blender e has been inserted into the ingre-
dients .
button / 2 pressed down during the whole
procedure . The appliance stops as soon as it
is released .
Do not operate the blender e for longer
than 1 minute at a time . After one minute of
use, allow the appliance to cool down fully .
blender e, release the Turbo button/ 2 and
remove the mains plug from the power socket .
Clean only the lower section of the blender e
under running water . Do not allow water to
get inside the blender e . This could result in
damage to the appliance .
socket 4 , press the blender release button 3
on both sides of the hand element q at
the same time . The blender e is now released
from the blender socket 4 .
from the blender socket 4 .
If the blender e still cannot be removed from
the blender socket 4 , pull the safety catch
open a little . Then the blender e can be
removed .
SHMS 300 C2