Table of Contents
Advertisement
7.5.2
Ambient conditions
7.5.2.1
Transport and storage conditions
Proper transport and storage, installation and assembly as well as careful operation and
maintenance are prerequisites for trouble-free and safe operation of the device.
Non-compliance with these regulations shall render the device warranty void.
Mechanical transport and storage conditions
The following information is for a device that is transported and stored in its original
packaging.
The device meets the requirements according to EN/IEC 61131-2 with the following
amendments and limitations:
Type of condition
Free fall
Vibration according to IEC 60068-2-6
Shock according to IEC 60068-2-27
Climatic transport and storage conditions
The following information applies to a device that is transported in the original packaging
and weather-proof packaging, and stored from some time.
The device meets the requirements according to EN/IEC 61131-2 with the following
amendments and limitations:
Type of condition
Temperature
Atmospheric pressure,
altitude
Relative humidity
Note
If dewing has developed, wait until the HMI device has dried completely before switching it
on.
Do not expose the HMI device to direct radiation from a heater.
IFP Basic
Operating Instructions, 06/2023, A5E46178354 - AD
Permitted range
≤ 1 m
5 to 8.4 Hz, deflection 3.5 mm
8.4 to 500 Hz, acceleration 1 g
250 m/s
Permitted range
IFP Basic: –20 to 60 °C
IFP1200 Basic C: –20 to 70 °C
1140 to 660 hPa, corresponds to an elevation of -1000 to 3500 m
5% to 95% at 25/55 °C, no condensation
Technical information
7.5 Technical specifications
, 6 ms, 1000 shocks
2
69
Advertisement
Table of Contents
