Polaris RANGER 1000 2023 Owner's Manual page 55

SEATING - PREMIUM MODELS
SEAT REMOVAL
To remove the driver's seat, lift up on the rear of the seat and rotate the seat
base up and forward.
For the passenger seat, pull the rear edge of the seat upward to release the
latch pins from the grommets. Then roll the seat forward to access the
under-seat area. To completely remove the seat, roll the seat forward and lift the
seat tabs from the seat base mounts.
SEAT BELT INSPECTION
Failure to perform regular inspection can reduce the effectiveness of the seat
belt during a crash and could result in serious injury or death.
Inspect all seat belts for proper operation before each use of the vehicle.
1. Push the latch plate into the buckle until it clicks. The latch plate must slide
smoothly into the buckle. A click indicates that it's securely latched.
2. Push the red release latch in the middle of the buckle to make sure it
releases freely.
3. Pull each seat belt completely out and inspect the full length for any damage,
including cuts, wear, fraying or stiffness. If any damage is found, or if the seat
belt does not operate properly, have the seat belt system checked and/or
replaced by an authorized dealer.
4. To clean dirt or debris from the seat belts, sponge the straps with mild soap
and water. Do not use bleach, dye or household detergents. Rinse the entire
length of the belt webbing. Use a garden hose to flush out the retractor and
latch housings regularly.
FEATURES AND CONTROLS
WARNING
53