Polaris RANGER 1000 2023 Owner's Manual page 124

MAINTENANCE
LIGHTS
Poor lighting can result in reduced visibility when driving. Headlight and taillight
lenses become dirty during normal operation. Clean lights frequently and
replace burned out lamps promptly. Do not operate this vehicle at night or in low
light conditions until the headlight is replaced. Always make sure lights are
adjusted properly for best visibility.
When servicing a halogen lamp, don't touch the lamp with bare fingers. Oil from
your skin leaves a residue, causing a hot spot that will shorten the life of the
lamp.
HEADLIGHT BULB REPLACEMENT
1. Remove the hood from the front cab.
2. Locate the bulb on the back side of the headlight housing.
3. Disconnect the harness from the bulb. Be sure to pull on the connector
not on the wiring.
4. Turn the bulb counterclockwise and remove it from the headlight housing, as
shown above.
5. Install the new bulb into the housing and rotate it clockwise 90° to lock it in
place.
Make sure the tab on the bulb locates properly in the housing.
6. Install the harness onto the new headlight bulb and install the hood.
122
NOTE
q
,