Assembly - NordicTrack C4si User Manual

ASSEMBLY

Assembly requires two persons. Place all parts of the exercise cycle in a cleared area and remove the pack-
ing materials. Do not dispose of the packing materials until assembly is completed.
In addition to the included tool(s), assembly requires a Phillips screwdriver , an adjustable
wrench , and a rubber mallet .
As you assemble the exercise cycle, use the drawings below to identify small parts. The number in parentheses
below each drawing is the key number of the part, from the PART LIST near the end of this manual. The number
following the parentheses is the quantity needed for assembly. Note: If a part is not in the hardware kit,
check to see if it has been preassembled.
M4 x 8mm
M8 Jam M6 Washer M8 Split
M10 Locknut
Screw (92)–1
Washer (55)–10
Locknut (89)–2 (87)–2 (44)–4
M4 x 16mm
M6 x 18mm Patch M6 x 38mm Patch M6 x 42mm Patch
Flange
Screw (77)–2 Screw (81)–4 Screw (51)–2
Screw (80)–4
M8 x 53mm Button
M8 x 16mm Patch M8 x 50mm Patch
Bolt (72)–2
Screw (54)–6 Screw (52)–4
M10 x 32mm
M10 x 63mm Bolt Set (62)–1
Button Bolt (78)–2
5