Suzuki DF25A 2014 Owner's Manual page 25

NOTICE
If you operate the boat with the motor trimmed
beyond the maximum trim position, the water
intake holes may be above the water line,
causing severe engine damage due to over-
heating.
Never operate the boat with the motor
trimmed beyond the maximum trim position.
TRIM TAB ADJUSTMENT
This adjustment is used to compensate for the
possible tendency of your boat to veer slightly
to port or starboard. This tendency could be
due to such things as propeller torque, motor
mounting position, etc.
To adjust the trim tab:
1. Loosen the bolt A that holds the trim tab in
place.
2. If the boat tends to veer to port, move the
rear end of the trim tab toward the port side.
If the boat tends to veer to starboard, move
the starboard side.
22
3. Tighten the bolt that holds the trim tab in
place.
After adjusting the trim tab, check to see if the
boat still tends to veer to one side. If necessary,
readjust the trim tab.
STEERING TENSION ADJUSTMENT
The steering on your outboard motor should be
smooth and not tight. Adjust the steering ten-
sion so that there is only a slight resistance to
steering movement.
TILLER HANDLE MODEL
To increase the steering tension, move the lever
A to the left. To decrease the steering tension,
move the lever to the right.
NOTE:
Do not apply a grease to the area B.