JETWAY MI23 Series User Manual page 35

Use this item to designates this port as Hot Pluggable.
The optional settings are: [Enabled]; [Disabled].
 PCH-FW Configuration
Use this item to configure Management engine technology parameters
Press [Enter] to make settings for the following sub-items:
TPM Device Selection
Use this item to selects TPM device: PTT or dTPM. PTT- Enables PTT in SkuMgr
dTPM 1.2 – Disables PTT in SkuMgr Warning! PTT/dTPM will be disabled and all
data saved on it will be lost
The optional settings are: [dTPM]; [PTT].
 Firmware Update Configuration
Use this item to configure management engine technology parameters.
Me FW Image Re-Flash
Use this item to enable/disable Me FW Image Re-Flash function
The optional settings: [Disabled]; [Enabled]
 Trusted Computing
Press [Enter] to view ME information and make settings in the following sub-items:
Security Device Support
Use this item to enables or disables BIOS support for security device. O.S will not
Show security device. TCG EFI protocol and INT1A interface will not be available.
The optional settings: [Disabled]; [Enabled].
When set as [Enabled], user can make settings in the following items that appear:
Pending operation
Use this item to schedule an operation for the security device. NOTE: Your computer
will reboot during restart in order to change state of security device
The optional settings: [None]; [TPM Clear].
TPM Device Selection
Use this item to selects TPM device: PTT or dTPM. PTT-Enables PTT in SkuMgr
dTPM 1.2 – Disables PTT in SkuMgr Warning! PTT/dTPM will be disabled and all
data saved on it will be lost
The optional settings: [dTPM]; [PTT].
 ACPI Settings
Press [Enter] to make settings for the following sub-items:
30