Daikin ETSH12P50EF User Reference Manual page 51

ETSH/X(B)12P30+50EF
Daikin Altherma 3 H MT ECH₂O
4P663480-1A – 2022.07
c Smartphone + app
Configuration
To configure the ONECTA app, follow the in-app instructions. While doing this, the
following actions and information are needed on the user interface of the indoor
unit:
D
User profile
Operation
Wireless gateway
Malfunctioning
Room
[D.1] Mode: Turn AP mode ON (= WLAN module active as access point):
1 Go to [D.1]: Wireless gateway > Mode.
2 In the Enable AP mode screen, select Yes.
[D.2] WPS: Connect the WLAN module to the router:
1 Go to [D.2]: Wireless gateway > WPS.
2 In the Connect to home network screen, select OK.
[D.3] Reboot: Reset the WLAN module:
1 Go to [D.3]: Wireless gateway > Reboot.
2 In the Reboot the gateway screen, select OK.
[D.4] Device info: Consult information about the WLAN module:
1 Go to [D.4]: Wireless gateway > Device info.
2 Read out SSID, MAC address, and Serial number.
INFORMATION
Restriction: WLAN settings are only visible when a WLAN cartridge is inserted in the
user interface.
About the WLAN cartridge
The WLAN cartridge connects the system to the internet. As user you can then
control the system via the ONECTA app.
This needs the following components:
a WLAN cartridge
b Router
The ONECTA app needs to be installed on the
user's smartphone. See:
http://www.onlinecontroller.daikineurope.com/
[D] Wireless gateway
[D.1] Mode
[D.2] WPS
[D.3] Reboot
[D.4] Device info
The WLAN cartridge needs to be inserted in the
user interface.
Field supply.
5 Operation
|
User reference guide
51