Infrastructure Connection - Canon WFT-E6 Manual

Infrastructure Connection

When the camera is set to
up to 4 network configuration profiles for different networks and select which one to use
depending on where you plan to use the camera.
mode, connect the camera to an access point. You can save
1
Set the camera to
the [Connection Settings] submenu.
[w System Setup] > [Network Settings] >
[Connection Settings]
The current network configuration will be displayed
on the screen. Push the joystick up/down or turn
the SELECT dial to select a different network
configuration profile.
2
Press SET to display the connection
settings of the selected network
configuration.
The current connection settings will be displayed
on the screen.
To use the current settings, select [OK] and press
SET. The rest of the procedure is not necessary.
To change the settings, select [Edit], press SET
and continue with the next step.
3
Select the method you wish use to set
up the access point connection and
press SET.
Refer to the descriptions of each method (A 7)
and select the most appropriate one depending on
the characteristics of the access point you plan to
use. Continue with the procedure explained in the
relevant page.
[WPS: Button], [WPS: PIN Code] (A 12)
[Search for Access Points] (A 14)
[Manual] (A 15)
mode and open
11