Pro-Form 705 CST User Manual page 13

16. Make sure that there is a piece of cardboard
below the rear of the Frame (56).
See page 15 and plug in the power cord. Next,
see page 17 and turn on the power. The incline
system will automatically calibrate and the
Frame (57) will move up and down. If the in-
cline system does not automatically calibrate,
see page 26 and manually calibrate the incline
system.
Then, press the Incline increase button once.
When the Frame (56) stops moving, remove the
key from the console and unplug the power
cord.
17. IMPORTANT: Before you begin this step,
make sure that you have calibrated the in-
cline system as described in step 16.
Raise the Frame (56) to the position shown.
Have a second person hold the Frame until
this step is completed.
Orient the Storage Latch (53) so that the large
barrel and the latch knob are oriented as shown.
Attach the upper end of the Storage Latch (53)
to the bracket on the Frame (56) with a 3/8" x
1 3/4" Bolt (6) and a 3/8" Nut (12).
Attach the lower end of the Storage Latch (53) to
the Base (94) with a 3/8" x 2" Bolt (3) and a 3/8"
Nut (12). Note: It may be necessary to move the
Frame (56) back and forth to align the Storage
Latch with the Base.
All manuals and user guides at all-guides.com
13
16
56
17
56
12
Latch
Knob
Large
Barrel
94
12
Cardboard
6
53
3