Installing the Ultrasonic Stack
If the ultrasonic stack is not installed in the press, follow the instructions below, depending on the model.
1. Activate the E-STOP (Abort) switch on the front of the press base shown in Fig. 4-2 below.
2. Turn off power to the generator by placing the AC switch in the "0" position.
3. Loosen all four transducer door screws as shown if Fig. 4-3, then set the door aside.
Figure 4-2 E-STOP Button (ABOrT)
403-624-00 P220 Pneumatic Ultrasonic Press System USER MANUAL
Figure 4-3 Door removal Screws
23