To Connect The Main Power Supply - Daikin ETVZ16S23EA9W Installation Manual

6 Electrical installation
Item
Heat pump convector There are different controllers and
setups possible for the heat pump
convectors.
Depending on the setup, you also
need to implement a relay (field
supply, see addendum book for
optional equipment).
For more information, see:
▪ Installation manual of the heat
▪ Installation manual of the heat
▪ Addendum
Wires: 0.75 mm²
Maximum running current: 100 mA
For the main zone:
▪ [2.9] Control
▪ [2.A] Thermostat type
For the additional zone:
▪ [3.A] Thermostat type
▪ [3.9] (read-only) Control
Remote outdoor See:
sensor
▪ Installation manual of the remote
▪ Addendum
Wires: 2×0.75 mm²
[9.B.1]=1 (External sensor =
Outdoor)
[9.B.2] Ext. amb. sensor offset
[9.B.3] Averaging time
Remote indoor sensor See:
▪ Installation manual of the remote
▪ Addendum
Wires: 2×0.75 mm²
[9.B.1]=2 (External sensor = Room)
[1.7] Room sensor offset
Human Comfort See:
Interface
▪ Installation and operation manual of
▪ Addendum
Wires: 2×(0.75~1.25 mm²)
Maximum length: 500 m
[2.9] Control
[1.6] Room sensor offset
Installation manual
12
Description
pump convectors
pump convector options
book for optional
equipment
outdoor sensor
book for optional
equipment
indoor sensor
book for optional
equipment
the Human Comfort Interface
book for optional
equipment
Item
WLAN module See:
▪ Installation manual of the WLAN
▪ Addendum
Use the cable delivered with the
WLAN module.
[D] Wireless gateway
WLAN cartridge See:
▪ Installation manual of the WLAN
▪ Installer reference guide
[D] Wireless gateway
for room thermostat (wired or wireless):
In case of...
Wireless room thermostat ▪ Installation manual of the wireless
room thermostat
▪ Addendum
equipment
Wired room thermostat ▪ Installation manual of the wired room
without multi-zoning base thermostat
unit
▪ Addendum
equipment
Wired room thermostat ▪ Installation manual of the wired room
with multi-zoning base unit thermostat (digital or analogue) +
multi-zoning base unit
▪ Addendum
equipment
▪ In this case:
▪ You need to connect the wired
▪ You need to connect the multi-
▪ For cooling/heating operation, you
6.3.1

To connect the main power supply

1 Open the following (see "4.2.1 To open the indoor
1 Top panel
2 User interface panel
3 Upper switch box cover
2 Connect the main power supply.
In case of normal kWh rate power supply
Interconnection Wires: (3+GND)×1.5 mm²
cable (= main
power supply)
—
Description
module
book for optional
equipment
cartridge
See...
book for optional
book for optional
book for optional
room thermostat (digital
analogue) to the multi-zoning base
unit
zoning base unit to the outdoor unit
also need to implement a relay
(field supply, see addendum book
for optional equipment)
unit" [ 4 6]):
1
ETVZ16S18+23EA6V+9W
Daikin Altherma 3 H HT F
4P644730-1 – 2021.02
or
3
2