Remington HC610 Manual page 6

STEP 4 – Top of the head (Diagram D)
Set the comb position between 19mm and 23mm, cut hair on top of the head against the
direction in which the hair normally grows.
For longer hair on top, use without comb attachment. Lift the hair on top of the head with
a small hand comb. Cut over the hand comb with the hair lifted or hold the hair between
the fi ngers to lift it and cut it to the desired length.
Always work from the back of the head.
STEP 5 – The fi nishing touches (Diagrams E, F & G)
Use the clipper without an attachment comb for close trimming around the base and sides
of the neck.
To produce a clean straight line at the sideburns, reverse the hair clipper. Place the
reversed clipper at right angles to the head, tips of the blades lightly touching the skin and
then work downwards.
CARE FOR YOUR HAIRCLIPPER
Your clipper is fi tted with high quality titanium/nanosilver blades. To ensure long lasting
performance of your clipper, clean the blades and unit regularly.
AFTER EACH USE
Ensure the clipper is switched off and disconnected from the mains.
Brush the accumulated hair from the blades. Do not submerge the clipper in water.
To clean the unit, wipe with a damp cloth and dry immediately.
Note: Ensure that the clipper is turned off when cleaning.
CAUTION:
Do not use liquid cleaners on the blades or harsh or corrosive chemicals on
the blade casing. Always use a soft brush to remove the accumulated hairs.
Unplug the charge adaptor from the power outlet when fi tting or removing attachments,
or while cleaning the product.
Always store this appliance and cord in a moisture-free area.
Do not wrap the cord of the charging adaptor around the appliance.
4
070777_REM_IFU_HC610_INT.indd 4 070777_REM_IFU_HC610_INT.indd 4
ENGLISH
Suitable for cleaning under water.
11.26.2007 12:17:19 Uhr 11.26.2007 12:17:19 Uhr