Connecting To A Power Source; Figure 3-6 Power Sockets - SMC Networks TigerSwitch SMC6128PL2 Installation Manual

I
NSTALLING THE

Connecting to a Power Source

To connect a device to a power source:
1. Insert the power cable plug directly into the socket located at the back
of the device.
2. Plug the other end of the cable into a grounded, 3-pin socket.
Note: For International use, you may need to change the AC line
3. Check the front-panel LEDs as the device is powered on to be sure
the Power LED is lit. If not, check that the power cable is correctly
plugged in.
3-8
S
WITCH
RATING
100~240V-
3A 50~60HZ
Figure 3-6 Power Socket
cord. You must use a line cord set that has been approved for
the socket type in your country.