Connecting To Pcs, Servers, Hubs And Switches; Figure 4-1 Making Twisted-Pair Connections - SMC Networks SMC8724ML3 Installation Manual

M N
AKING ETWORK

Connecting to PCs, Servers, Hubs and Switches

1. Attach one end of a twisted-pair cable segment to the device's RJ-45
connector.
2. If the device is a PC card and the switch is in the wiring closet, attach
the other end of the cable segment to a modular wall outlet that is
connected to the wiring closet. (See "Network Wiring Connections"
on the next page.) Otherwise, attach the other end to an available port
on the switch.
Make sure each twisted pair cable does not exceed 100 meters (328 ft)
in length.
3. As each connection is made, the Link LED (on the switch)
corresponding to each port will light green (1000 Mbps) or amber
(10/100 Mbps) to indicate that the connection is valid.
4-2
C
ONNECTIONS

Figure 4-1 Making Twisted-Pair Connections