Connecting To A Power Source; Figure 3-8 Power Socket - SMC Networks SMC8724ML3 Installation Manual

Connecting to a Power Source

To connect a device to a power source:
1. Insert the power cable plug directly into the socket located at the back
of the device.
2. Plug the other end of the cable into a grounded, 3-pin, AC power
source.
Note: For international use, you may need to change the AC line
3. Check the front-panel LEDs as the device is powered on to be sure
the Power LED is on. If not, check that the power cable is correctly
plugged in.
4. If you have purchased a Redundant Power Unit, connect it to the
device and to an AC power source now, following the instructions
included with the package.

Figure 3-8 Power Socket

cord. You must use a line cord set that has been approved for
the socket type in your country.
C
ONNECTING TO A
100 -240V~
50-60Hz 2A
P S
OWER OURCE
3-13