Canceling Active Program; After Washing; Cleaning And Care; Cleaning The Washer - Bosch Nexxt DLX Series Operating, Care And Installation Instructions Manual

i If the spin speed is too high, the
Start/Pause indicator light is lit
(red). Laundry can be added in
Pause" mode when the drum is at
a standstill.
Canceling an active
program
If you would like to terminate a program
and remove the laundry:
i If a program is interrupted at a high
temperature, leave the laundry to
cool down until the glass is cool to
touch.
q Turn the program selector to Off.
q Turn the program selector to Drain
or Spin.
i For Spin, select the desired spin
speed (but not no final spin).
q Press the Start/Pause button.
q Wait until this program ends.
q Open the door.
q Unload the laundry.
i If a program is interrupted at a high
temperature, the door may remain
locked until the appliance has
cooled down.
i If the program is terminated by
switching off the appliance, the
door may remain locked.
20
All manuals and user guides at all-guides.com

After Washing

The Start/Pause indicator light goes
out.
0:00 appears in the display.
q Open the door.
q Turn the program selector to Off.
q Close the taps.
q Remove the laundry.
If No final spin" preselected
The Start/Pause indicator light flashes.
q Turn the program selector to
Drain. The Start/Pause indicator
light flashes.
q Press the Start/Pause button.
The indicator light is lit.
q When this program has ended,
open the door.
q Turn the program selector to Off.
q Close the taps.
q Remove the laundry.
i Leave the loading door ajar to
allow the inside of the washing
machine to dry.
Cleaning and
Care

Cleaning the washer

d
WARNING
TO AVOID RISK OF ELECTRIC
SHOCK!
Always disconnect the appliance
from the power outlet before
cleaning.
Never clean the washing machine
with a pressure washer.
d
WARNING
TO AVOID RISK OF EXPLOSION!
Never use flammable solvents to
clean the appliance.
CAUTION
Occasionally check for any foreign
objects (e. g. coins, paper clips)
between the drum and rubber seal
-TO AVOID Risk of rust!
Cleaning the appliance housing
and control panel
As required:
q Use hot soapy water or a mild,
non abrasive cleaning agent.
q Rub dry with a soft towel.
Cleaning the drum
If rust spots have formed due to
left over debris (e.g. coins, paper clips,
nails):
q Use a chlorine free cleaning agent.
Follow the manufacturer's
instructions. Never use steel wool.
Cleaning the detergent dispenser
If residual detergents or additives have
accumulated
or if softener/bleach are not fully rinsed
out:
q Open the flap of the detergent
dispenser.
d
d