Table of Contents
Advertisement
H8SSP-8/H8SSP-i User's Manual
I
2
C to PCI Enable/Disable
JI
2
C1/2 pair of jumpers allow you to
connect the System Management Bus
to any one of the PCI slots. The default
setting is closed for both jumpers to en-
able the connection. Both connectors
must have the same setting (JI
2
for data and JI
C2 is for the clock). See
the table on right for jumper settings.
DOC IDE Bus Select
Jumper JP17 allows the user to choose
either master or slave mode for a DOC
(Disk-On-Chip) device that has been
plugged into the IDE slot. See the ta-
ble on right for jumper settings.
2-8
Onboard Indicators
JLAN1/JLAN2 LEDs
The Ethernet ports (located beside
the VGA port) have two LEDs. On
each Gb LAN port, the right (yellow)
LED indicates activity while the left
(orange) LED indicates when there is
a connection (link). See the table on
the right for the functions associated
with the left (connection) LED.
+3.3V Power LED
When illuminated, the DP1 LED
indicates that power from the pow-
er supply is being supplied to the
serverboard (DP1 indicates the pres-
ence of +3.3V). See the table on the
right for DP1 LED states.
I
2
C to PCI Enable/Disable
Jumper Setting
Closed
2
C1 is
Open
DOC IDE Bus Select
Enable/Disable Jumper
Jumper Setting
Open
Closed
(Connection Indicator)
LED Color
Off
Orange
State
System Status
On
Power present on serverboard
Off
No power present on serverboard
2-16
Jumper Settings
2
2
(JI
C1/JI
C2)
Defi nition
Enabled
Disabled
Settings (JP17)
Defi nition
Slave
Master
JLAN Left LED
Defi nition
No Connection
Connection
+3.3V Power LED
(DP1)
Advertisement
Table of Contents
