Graco 253017 Instructions-Parts List Manual page 8

Mounting Pumps with an Intake Housing
Flange
NOTE: The Pump Mounting Chart on page 3 lists the
parts necessary to mount pumps with an intake hous-
ing flange on this ram. Installing other pumps on the
ram may require alternate parts. For information,
contact your Graco distributor.
1. Position the mounting brackets (57) so that the top
of the pump will clear the support beam (3).
2. Attach the motor to the mounting brackets (57)
with the fasteners supplied, as applicable.
3. Loosen the mounting bracket setscrews (35), and
carefully lower the pump until the intake valve is
below the gasket (H), then tighten the setscrews.
4. Align the holes in the intake housing flange (N)
with those in the gasket (H) and ram plate (63).
Secure tightly to the ram plate with the four
screws (D) and washers (C). See Fig. 6.
8 306934
Setup
N
H
63
Fig. 6
NOTE: Ram 241988 does not include an inductor
plate. Pumps may be mounted by connecting the air
motor to bracket 161822 and connecting the inductor
plate (C58391) and o-ring (109482) to the inlet of the
pump by means of the included setscrew.
D
C
02939