Installing The Barcode Reader - Royal 600sc Instruction Manual

Chapter 2: Getting Started
4 Grab the small handle on the right
5 Lay the end of the paper across the
6 Do one of the following:

Installing the Barcode Reader

Your cash register comes with a barcode reader. It allows you to scan
items with a UPC symbols, instead of using the keyboard to type the PLU
number.
The barcode reader plugs into the port on the lower right side of the cash
register. Use the directions below to install it.
To install and program the barcode reader
1 Unpack the reader from the box.
2 Turn the Mode key to OFF.
6
of the print roller. Push the little
handle towards the back of the cash
register and raise the roller bar up.
printer as shown. Move the print
roller down onto the paper and
snap into place. Make sure both
sides are snapped down.
• Press the Feed key until the paper
catches and moves through the printer.
• If you do not need to print receipts:
Place the black plastic Journal Takeup
spindle on its grooves above the Battery
compartment. The spindle sits above the
paper roll. Press the Feed key to move
the paper through the printer about
10-12 inches. Push the paper through
one of the narrow openings in the center
of the Journal Takeup spindle. Press the
Feed key until the paper catches and
begins to wind securely around the
Journal Takeup spindle. Replace the Journal Compartment Cover.
• If you want to print receipts:
Lay the customer receipt paper over the receipt slot and close the
Journal Compartment Cover.
Handle
Alpha 600sc User's Guide