Table of Contents
Advertisement
Danger
Battery electrolyte contains sulfuric acid which is
a deadly poison and causes severe burns.
Do not drink electrolyte and avoid contact with
skin, eyes or clothing. Wear safety glasses to
shield your eyes and robber gloves to protect
your hands.
Fill the battery where clean water is always
available for flushing the skin.
Follow all instructions and comply with all
safety messages on the electrolyte container.
1. Remove the battery from the machine. Refer to
Removing the Battery on page 36.
2. Clean the top of the battery with a paper towel.
Note: Never fill the battery with electrolyte while the
battery installed in the machine. Electrolyte can be spilled
on other parts and cause corrosion.
3. Remove the vent caps from the battery (Fig. 42).
4. Slowly pour electrolyte into each battery cell until the
level is up to the "UPPER" line (Fig. 42) on the
battery case.
Important
Do not overfill the battery because
electrolyte (sulfuric acid) can cause severe corrosion and
damage to the chassis.
5. Wait five to ten minutes after filling the battery cells.
Add electrolyte, if necessary, until the electrolyte level
is up to the "UPPER" line (Fig. 42) on the battery
case.
6. Reinstall battery filler caps.
2
3
1
Figure 7
1. Filler caps
2. UPPER line
All manuals and user guides at all-guides.com
3. LOWER line
17
Warning
Charging battery produces gasses that can
explode and cause serious injury.
Keep cigarettes, sparks and flames away from
battery.
Make sure the ignition switch is off.
Ventilate when charging or using battery in an
enclosed space.
7. Make sure the vent caps are installed in the battery.
Charge the battery for 1 hour at 25 to 30 amps or 6
hours at 4 to 6 amps. Do not overcharge the battery.
8. When the battery is fully charged, unplug the charger
from the electrical outlet, then disconnect the charger
leads from the battery posts (Fig. 8).
4
2
Figure 8
1. Positive Battery Post
2. Negative Battery Post
9. Install the battery in the machine and connect the
battery cables. Refer to Installing Battery on page 36.
Note: Do not run the tractor with the battery disconnected,
electrical damage may occur.
Checking the Hydraulic Fluid
Check the hydraulic fluid level before engine is first
started.
Fluid Type: Mobil 1 15W-50 synthetic motor oil or
equivalent synthetic oil.
Important
Use oil specified or equivalent. Other
fluids could cause system damage.
Hydraulic System Oil Capacity: 67 oz. (2.0 l)
1. Position machine on a level surface and chock or block
tires.
3
1
3. Red (+) Charger Lead
4. Black (–) Charger Lead
Advertisement
Table of Contents
