Table of Contents
Advertisement
3. Turn ignition key "START" to energize starter. When
engines starts, release key (Fig. 13).
Important
Do not engage starter for more than 5
seconds at a time. If engine fails to start allow 15 second
cool-down period between attempts. Failure to follow
these instructions can burn out starter motor.
4. When engine starts, move the throttle control between
the "FAST" and "Slow" position. Allow engine to
warm up and then move the throttle control to the
"FAST" position.
Stopping
1. Move the throttle lever to "SLOW" (Fig. 13).
Note: If the engine has been working hard or is hot, let it
idle for a minute before turning the ignition key "OFF."
This helps cool the engine before it is stopped. In an
emergency, the engine may be stopped by turning the
ignition key to "OFF."
2. Turn the ignition key to "OFF" (Fig. 13).
Figure 13
1. Throttle lever
Note: Pull wire off spark plug(s) to prevent possibility of
someone accidentally starting before transporting or
storing machine.
Important
Make sure fuel shut off valve is closed
before transporting or storing machine, as fuel leakage
may occur.
All manuals and user guides at all-guides.com
2
1
m–5187
2. Ignition key
20
Operating Mower Blade
Control (PTO)
The blade control switch (PTO) in conjunction with the
blade control bail engages and disengages power to the
electric clutch and mower blades.
Engaging the Mower Blades (PTO)
1. Release the upper control bar to stop the machine
(Fig. 14).
2. To engage blade, squeeze blade control bail against
upper control bar (Fig. 14).
3. Pull blade switch (PTO) up and release. Hold blade
control bail against control bar while operating.
4. Repeat procedure to engage mower blades if blade
control bail is released.
1
3
Figure 14
1. Upper control bar
2. Blade control bail
Disengaging the Mower Blades (PTO)
1. Release blade control bail to disengage blades
(Fig. 14).
2
m–5187
3. Blade switch (PTO)
Advertisement
Table of Contents
