Checking The Engine Oil Level; Checking The Hydraulic-Fluid Level; Checking The Tire Pressure - Toro 72076 Setup Instructions

1
Adding Fuel to the Machine
No Parts Required
Procedure
Add fuel to the machine before starting it. Refer
to your Operator's Manual for the correct fuel and
procedure.
2
Checking the Engine-Oil
Level
No Parts Required
Procedure
Before you start the engine and use the machine,
check the oil level in the engine crankcase; refer to
the Operator's Manual.
3

Checking the Tire Pressure

No Parts Required
Procedure
Front and rear tires air pressure specification: 124
kPa (18 psi).
Note:
Check the tire pressure before starting the
machine. Refer to your Operator's Manual for the
correct tire type, correct air pressure needed, and
procedure.
4
Checking the
Hydraulic-Fluid Level
No Parts Required
Procedure
1. Park the machine on a level surface, disengage
the blade-control switch, and engage the parking
brake.
2. Move the motion-control levers to the
N -
EUTRAL LOCK
Note:
Run the engine at the lowest possible
rpm to purge any air in the system.
Important:
Do not engage the PTO.
3. Raise the deck to extend the lift cylinders, shut
off the engine, and remove the key.
4. Raise the seat to access the hydraulic-fluid tank.
5. Remove the hydraulic-tank cap
1. Hydraulic-tank cap
2. Dipstick
6. Remove the dipstick and wipe it with a clean rag
(Figure 1).
7. Place the dipstick into the filler neck, remove it,
and check the fluid level
Note:
If the level is not within the notched area
of the dipstick, add enough high-quality hydraulic
fluid to raise the level to within the notched area.
Important:
Do not overfill.
2
position and start the engine.
(Figure
Figure 1
3. Filler neck
(Figure 2).
1).
g227849