Table of Contents
Advertisement
1-2. Precautions to be taken when using the laser
1) Be sure to check the head section of the laser to clean it up to remove the accumulated combustion
impurity every working day before commencing the work.
2) Check atmospheric pressure and adjust it to 0.5 - 0.55 MPa every working day before commending
the work.
3) Be sure to check whether the cooling water tank and suction fan of the equipment normally operate
and also check the suction fan for abnormal noise and the cooling water tank for errors every work-
ing day before starting the work.
4) Be sure to check the cooling water tank of the laser contains an adequate amount of commercially
available pure water.
5) Turn OFF the power switch every working day at the end of the work.
6) Be sure to place the exhaust pipe of the suction fan in an outdoor location and attach a combustion
deodorizing filter to its outer connector.
7) This product is a Level-4 no observation light laser product. Anybody who has not received the pro-
fessional training must remain away from this product to protect against injury.
8) Whenever you want to carry out maintenance / repair of the laser equipment of this product, be sure
to contact our After-Sale Service Department. The professional staff who has received professional
training in JUKI to gain experience of the relevant work will carry out maintenance / repair of your
product.
Supplementary materials
1) Laser head
It is prohibited to observe the laser
tube with an optical telescope or
directly look at the optical path while
the laser is in operation, from the
locations as shown in the figure.
Outdoor
5) Power switch
C
4) Cooling water tank
3) Suction fan
6) Suction pipe
A
B
A: Reflecting mirror of the laser
B: Focusing lens of the laser
C: Laser tube
– 4 –
Indoor
Advertisement
Table of Contents
