Table of Contents
Advertisement
1-1. Precautions to be taken when installing or adjusting the laser
1) If the laser intensity is excessively high, take care not to directly look into the laser in order to protect
your eyes. Be sure to wear safety goggles during work.
2) Take care not to irradiate the mirror surface with laser light in order to prevent reflection.
3) Laser current during the adjustment: Adjustment of the laser current during adjustment is prohibited.
The factory-set value at the time of shipment must be used as the standard value.
4) Be sure to use the adjustment mode when you adjust this product. (Refer to
laser"
p.21.)
5) Visible angle during work or adjustment (See the figure given below)
25°
Cutting position
– 3 –
"5-5. Adjusting the
No observation
Advertisement
Table of Contents
