Omron Promi-SD 205-OA User Manual page 37

Promi-SD User Manual – Appendix A. AT Commands
Purpose
Description
Reference
10 AT+BTRSSI,n 
SD Response
Purpose
Parameters
Description
Example
11 AT+BTMODE,n
SD Response
Purpose
Parameters
Description
Reference
Example
12 +++
SD Response
Purpose
Description
 OK
Display device firmware version
Display device firmware version
AT+BTINFO?
 OK
 0,255,0,0 (repeat)
Set operation mode
n=0: Start sensitivity test
n=1: Stop sensitivity test
When Bluetooth connection is established, you can use this command in Stanby status.
The sensitivity will be displayed repeatedly in order of Status, LinkQuality, Status, RSSI. If
the LinkQuality is close to 255 and RSSI is close to 0, the sensitivity is not bad.
+++
AT+BTRSSI,1
 OK
0,255,0,0
 OK
Set operation mode
n=0: MODE0 (Default)
n=1: MODE1
n=2: MODE2
n=3: MODE3
When the operation status is 'Pending' currently, change the status to 'Standby ' with
AT+BTCANCEL prior to this command.
To take effect of this command, ATZ or power off and on.
AT+BTINFO?
AT+BTMODE,2
 OK
ATZ
 OK
Convert the operation status of 'Connect' to 'Standby'
In 'Connect' status, data from host is transmitted to the other side Bluetooth device,
and any AT command is not accepted but this command, which is not echoed on the
screen.
When Promi-SD encounters a character '+' from host, it stops the data transmission and
waits for next 2 characters. If the next 2 characters aren't both '+', it restart to transmit
data including the first '+' as well. If not, it converts the operation status to 'Standby '.
If the data from host includes '+++', it will convert the operation status to 'Standby'
unexpectedly. Notice that Promi-SD holds data transmission when it encounters '+', until
receiving next character.
Copyright © 2006 Sena Technologies, Inc. All rights reserved.
A-6