Table of Contents
Advertisement
Promi-SD 205-OA User Manual – 2. Configurations
* Note: DO NOT power off Promi-SD while the firmware update is progressing, this may damage the Promi-SD.
Terminal Program
A terminal
program is an application that will enable a PC to
T
Windows 98SE or higher version of Windows, HyperTerminal program as it is included as part of the operating system.
Promi -SD provides some extended AT commands for its configurations on terminal program.
This manual will explain the method using HyperTerminal. If you need to install HyperTerminal, click start>setting>control
panel>add/remove programs. For more precise information, please refer to Help of Microsoft Windows.
Attach Promi-SD to serial port of PLC and power on. Check Status LED (Promi -SD202/205 OA) or Standby LED (Promi -
SD205) is lit in green.
Launch HyperTerminal. It can be found in start >programs >accessories >communication >HyperTerminal. Select the
Serial port that Promi-SD will be connected to.
Input the same settings into Serial port configuration window as Promi-SD settings.
The settings need to be set correctly, otherwise, error message may be shown up on the screen or cause
malfunctioning of Promi -SD.
Copyright © 2006 Sena Technologies, Inc. All rights reserved.
c ommunicate directly with a modem. If you are using
T
20
Advertisement
Table of Contents
