Table of Contents
Advertisement
Option
Description
HyperThread
Allows you to enable or disable the HyperThreading in the processor.
Control
● Disabled
● Enabled
Default setting: Enabled.
Power Management screen options
Option
Description
AC Behavior
You can enable or disable the computer from turning on automatically when an AC adapter is connected.
The option is:
● Wake on AC
This option is not selected by default.
Auto On Time
You can set the time at which the computer must turn on automatically. The options are:
● Disabled. This option is selected by default.
● Every Day
● Weekdays
● Select Days
USB Wake
You can enable USB devices to wake the system from Standby.
Support
The option is:
● Enable USB Wake Support
This option is disabled by default.
Wireless Radio
You can enable or disable the feature that automatically switches from wired or wireless networks without
Control
depending on the physical connection.The options are:
● Control WLAN Radio
● Control WWAN Radio
This option is disabled by default.
Wake on LAN/
You can enable or disable the feature that turns on the computer from the Off state:
WLAN
● When triggered by a LAN signal
● From the hibernate state when triggered by a special wireless LAN signal
The options are:
● Disabled. This option is set by default.
● LAN Only
● WLAN Only
● LAN or WLAN
Block Sleep
You can block entering to sleep (S3 state) in operating system environment. The option is:
● Block Sleep (S3 state)
This option is disabled by default.
Peak Shift
You can minimize the AC power consumption during the peak power times of day. After you enable this
option, your system runs only in battery even if the AC is attached. The option is:
● Enable Peak Shift
This option is disabled by default.
NOTE:
This feature is only functional when the AC power adapter is connected. If the AC power
adapter is removed during Standby, the system setup removes power from all the USB ports to
conserve battery power.
System setup
75
Advertisement
Table of Contents
