Table of Contents
Advertisement
system enters the sleep (S3) state, the battery LED continues to flash green/amber at the faster rate to indicate to the user
that a power source needs to be installed.
If the hot swap battery is not charged to a sufficient level or the temperature is outside the mentioned range and the user
performs a hot swap, the BIOS puts the system into the Sleep (S3) state and flashes the battery LED at a faster green/amber
rate.
Removing the battery
WARNING:
Using an incompatible battery may increase the risk of fire or explosion. Replace the battery only
with a compatible battery purchased from Dell. The battery is designed to work with your Dell computer. Do not
use a battery from any other computer with your computer.
WARNING:
Before removing or replacing the battery, turn off the computer, disconnect the AC adapter from
the electrical outlet and the computer, disconnect the modem from the wall connector and computer, and
remove any other external cables from the computer.
WARNING:
Not for use in hazardous locations. See installation instructions.
1. Follow the procedure in
2. Push and hold the battery release button to the right while pulling on the plastic battery tab.
Installing the battery
1. Slide the battery into the slot until it clicks into place.
2. Press firmly on the door until a click is heard and the latch is engaged.
3. Follow the procedure in
Hard drive
Removing the hard drive
1. Follow the procedure in
2. Remove the battery.
3. To remove the hard drive:
a. Unlock the hard drive press latch door [1].
b. Push it downwards to open it [2].
c. Push and hold the hard drive release button to the left while pulling on the plastic hard drive tab [3].
d. Pull the hard drive away from the computer [4].
Before Working Inside Your
After working inside your
Before working inside your computer
Computer.
computer.
Disassembly and reassembly
19
Advertisement
Table of Contents
