Table of Contents
Advertisement
• The LED is lit: the drive has failed.
• The LED is flashing slowly (once per second): the drive is being rebuilt.
• The LED is flashing rapidly (three times per second): the drive is being identified.
4
Front I/O module
For more information about the front I/O module, see
5
PCIe slot 3-6
Install PCIe adapters, particularly GPUs to these slots. These PCIe slots support the following configuration:
• PCIe Gen5 x16, FH/FL
6
PCIe slot 1-2
Install PCIe adapters, particularly network adapters to these slots. These PCIe slots support the following
configuration:
• PCIe Gen5 x16, FH/FL
7
2.5-inch hot-swap drive bays (0 to 7)
Install 2.5-inch drives to these bays. See "Install a 2.5- inch hot-swap drive" in ThinkSystem SR675 V3 User
Guide or Hardware Maintenance Guide for more information.
The 8-DW GPU Model front view
This section contains information about the controls, LEDs, and connectors on the front of the 8-DW GPU
Model server.
The 8-DW GPU Model offers two storage configurations, up to six EDSFF E1.S 5.9mm drives or up to four
EDSFF E3.S 1T drives. Refer to the following tables for front view identification of each storage configuration:
•
"Front view with 6x E1.S 5.9mm drives" on page 16
•
"Front view with 4x E3.S 1T drives" on page 18
Front view with 6x E1.S 5.9mm drives
Figure 3. Front view with 6x E1.S 5.9mm drives
ThinkSystem SR675 V3 System Configuration Guide
16
"Front I/O module" on page
23.
Advertisement
Table of Contents
